Shutters fitted when Amaroo was first built in the early 1990s have now been through more than thirty Canberra winters, and that is the single biggest factor in what we replace here. Springs lose tension, plastic hardens, and motors that were adequate when new begin to labour. Gungahlin housing of that era is largely single storey brick veneer with generous window openings at the front, so the shutters are wide enough that any loss of balance in the spring shows up quickly.
We cover all of Amaroo in the 2914 postcode, including the streets around the school and the shops and the newer pockets over toward the Moncrieff and Jacka side. Bonner, Forde, Ngunnawal and the Gungahlin town centre are on the same route, so a callout in any of them fits into the same run.
Brick veneer from the 1990s holds a fixing well, so the failures we find in Amaroo are usually inside the mechanism rather than at the wall.
Not every ageing motor needs replacing. Often the motor is fine and the problem is the load it is being asked to lift, so retensioning the spring and freeing the rails brings the current draw back down and the unit keeps going. We will tell you honestly which one you are looking at, because a motor genuinely at the end of its life will keep cutting out no matter what else is adjusted around it.
